1756-ENBT | Ethernet/IP Communication Bridge Module | Allen Bradley

1756-ENBT | Ethernet/IP Communication Bridge Module | Allen Bradley

The Allen-Bradley 1756-ENBT ControlLogix Ethernet/IP Bridge Module is a copper communication module used to transfer large volumes of data using an Ethernet connection. This module can handle 64 TCP and 128 CIP connections with a communication rate of 10 / 100 Mbps. This module supports high-speed processor interlocking, control distributed I/O, and route to devices on a different NetLinx network, using the Ethernet/IP network as a backbone. These capabilities allow users to control, configure, and collect data in just one Ethernet/IP network. In turn, this allows the users to cut back on maintenance and support costs and then simplify their network architecture because fewer networks may then be required to run their application.

Features :

• Model : 1756-ENBT
• Ethernet/IP communication rate : 10/100 Mbps
• Current draw @ 5.1V DC : 700 mA
• Current draw @ 24V DC : 3 mA
• Power dissipation : 3.7 W
• Thermal dissipation : 12.6 BTU/hr
• Isolation voltage : 30V (continuous), basic insulation type, Ethernet network to backplane, Type tested @ 707V DC for 60 s
• Slot width : 1
• Module location : Chassis-based, any slot
• Ethernet port : 1 Ethernet RJ45 Category 5
• Ethernet cable : 802.3 compliant shielded or shielded twisted pair
• Wiring category : 2 - on Ethernet ports
• North American temperature code : T4A
• IEC temperature code : T4
• Enclosure type rating : None (open-style)

Note :

• Use this conductor category information for planning conductor routing as described in the system level installation manual.